Chemistry AcidBase Titration Essay Research Paper Chemistry

Published: 2021-06-21 04:50:04
essay essay

Category: Chemistry

Type of paper: Essay

This essay has been submitted by a student. This is not an example of the work written by our professional essay writers.

Hey! We can write a custom essay for you.

All possible types of assignments. Written by academics

GET MY ESSAY
Chemistry: Acid-Base Titration Essay, Research Paper

Chemistry: Acid-Base Titration

Purpose:

The aim of this experiment were: a ) to reexamine the construct of

simple acid-base reactions ; B ) to reexamine the stoichiometric computations

involved in chemical reactions ; degree Celsiuss ) to reexamine the basic lab process of a

titration and present the pupil to the construct of a primary criterion and the

procedure of standardisation ; vitamin D ) to reexamine the computations affecting chemical

solutions ; vitamin E ) to assist the pupil better his/her lab technique.

Theory:

Titration was used to analyze acid-base neutralisation reaction

quantitatively. In acid-base titration experiment, a solution of accurately KHP

concentration was added bit by bit to another solution of NaOH concentration

until the chemical reaction between the two solutions were completed. The

equality point was the point at which the acid was wholly reacted with or

neutralized by the base. The point was signaled by a changing of colour of an

index that had been added to the acerb solution. Indicator was substance that

had clearly different colourss in acidic and basic media. Phenolphthalein was a

common index which was colorless in acidic and impersonal solutions, but

ruddy pink was result in basic solutions. Strong acid ( contained H+ ion ) and

strong base ( contained OH ) were 100 % ionized in H2O and they were all

strong electrolytes. Procedure:

Part A. Investigating solid NaOH for usage as a possible primary criterion First of

all, The weight of a weighting paper was measured in analytical balance, so

added two pell
ets of NaOH and reweighed the entire sum of those. At the terminal of
the lab, reweighed the combination and recorded all consequences in the lab manual.

Part B. Preparation and standardisation of a solution of Na hydrated oxide A

clean beaker, burette, three 250ml Erlenmeyer flasks, and Firenze flask were

rinsed by soap and distilled H2O. Poured 1.40g of NaOH into Firenze flask and

added 350ml distilled H2O, so twirl it and inverted flask five times with

parafilm on the top of it. Following, obtained a phial of KHP from the teacher, and

poured about 0.408g into three different Erlenmeyer flasks by mensurating with

analytical balance. Then, filled up about 25ml of distilled H2O, added 3 beads

of phenolphthalein into it and mixed them good by a glass rod. Labeled all

solutions to forestall blend them up. Before the titration began, the buret should

be rinsed with NaOH solution and recorded the initial buret reading. Titrated

the solutions until the ruddy pink colour appeared. Recorded the concluding reading,

and calculated the alteration of volume.

Part C. Determination of the molar mass of unknown acid Repeated the process

above, but this clip KHP was replaced with an unknown acidic solution and

concentration. Demanded the figure of replaceable H from the teacher.

Decision and Discussion: From the titration consequences of three test, the

norm of molar concentration of NaOH is 0.1021. The per centum divergence in molar concentration of

NaOH had 0.20 % mistake. The possible mistake in this experiment were: the mistake in

taking the buret readings, the mistake in mensurating sum of elements, and the

NaOH was non stable under air.

Warning! This essay is not original. Get 100% unique essay within 45 seconds!

GET UNIQUE ESSAY

We can write your paper just for 11.99$

i want to copy...

This essay has been submitted by a student and contain not unique content

People also read